全站搜索
why the bubble come out again after laminating
作者:管理员    发布于:2016-01-14 12:09:17    文字:【】【】【
The reason why bubble appear again after laminating:

     1.Firstly, pls choose good quality Mitsubishi OCA instead of bad quality;

     2.econdly, the temperature should be controlled under 35℃, or when turns to normal temperature, the Solubility of Air will reduce which will cause bubble again;

     3.Thirdly, no dust and no bubble when laminating OCA;

     4.fourthly, over pressure or long time operation also will cause bubble, as under high pressure, misoperation may forcibly remove the bubble which may appear again when back to normal pressure;
     5.Fifthly, delay too long time to remove bubble after laminating;

     6.Another reason is temperature difference: It is very cold in some countries in winter and there exists large temperature difference after taking out of bubble remover (the temperature in bubble remover is much higher than outside).
文章分类
自定内容
Address :
            4th Floor, Dong Sheng Fang Building, Shang Heng Lang              Industrial ,Longhua Dalang District, Shenzhen,China
Tel:     0086(755)-8398 6865
Fax:    0086(755)-8398 6865
Email:  tycoontl@tuolitech.com
给我留言
NAME: *
PHONE: *
MESSAGE: *
EMAIL: *